VIEWSONIC VS13647 - Manual (Page 42)

ViewSonic Pro8400 38
4. Press to select the item you want to modify and press ENTER on the projector
or Enter on the remote control.
5. Press / to move the cursor and the enter the value.
6. To save the settings, press ENTER on the projector or Enter on the remote
control. If you do not want to save the settings, press MENU/EXIT on the projector
7. or Menu on the remote control.
8. Press to highlight Apply and press ENTER on the projector or Enter on the
remote control.
Important
„ If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,
Default Gateway, and DNS settings will display 0.0.0.0. Make sure the
cables are properly connected and perform the procedures above again.
„ If you wish to connect to the projector in its standby mode, be sure you have
selected RJ45 and obtained the IP Address, Subnet Mask, Default Gateway,
and DNS information when the projector is on.