Westell Technologies Router 2400 - Manual (Page 55)

030-300331 Rev. A 53 October 2002
4-Port Router (Model 2400) User Guide
If you clicked on save, the following pop-up screen will be displayed. Click on OK. This will save you Private
LAN Configuration settings. If you click Cancel, your new settings will not take affect.
NOTE: DHCP Lease Time is displayed in the following format: (dd:hh:mm:ss)* This value must be greater than 10
seconds. The default = 01:00:00:00. Seconds must be between 0 and 59, minutes must be between 0 and 59, and
hours must be between 0 and 23.
*(dd = days, hh = hours, mm = minutes, ss = seconds).
If the settings you have entered in the Private LAN Configuration screen are incorrect, the following warnings
messages may be displayed via pop-up screens. If this occurs, check the settings in the Private LAN Configuration
screen.
Warning Message Check Private LAN DHCP Settings
Start Address is not part of the Subnet Check the value in the DHCP Start Address field
End Address is not part of the Subnet Check the value in the DHCP End Address field
End Address is below the Start Address Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 53 Check the Seconds value in the DHCP Lease Time field
Minutes must be between 0 and 59 Check the Minutes value in the DHCP Lease Time field
Hours must be between 0 and 23 Check the Hours value in the DHCP Lease Time field
Public LAN Configuration
The following screen will be displayed if you select Public LAN from the Configuration menu. The Public LAN
feature, if available from your service provider, allows the Router to use LAN IP addresses that are accessible from
the WAN. Public LAN allows your computer to have global addressability.
NOTE: Both Private LAN and Public LAN cannot be disabled.