Whirlpool 66161279 - Manual (Page 14)

14
Mode
1. Press MODE until you see the indicator light glow for the
desired setting.
2. Choose Cool, Eco (on some models), Overnight (on some
models) or Fan Only.
■ Cool—Cools the room. Fan Speed is set to Auto. Press
the up or down arrow button to adjust the temperature.
■ Eco (on some models)—Saves energy. The compressor
and fan runs until the set temperature is reached, and
then the compressor turns off. The fan runs an additional
minute before turning off. Automatically sets the fan
speed to Auto. Press the up or down arrow button to
adjust the temperature.
■ Overnight (8 hours) (on some models)—Automatically
raises the set temperature by 4ºF (2ºC). The Fan Speed is
set to Low. Press the up or down arrow button to adjust
the temperature. The set temperature increases 2ºF (1ºC)
per hour during the first 2 hours, and remains at this
temperature setting for the next 6 hours.
When Overnight mode ends, the air conditioner will go
into Cool mode and the thermostat setting will return to
the original Overnight mode temperature setting.
NOTE: The LEDs on the control panel will power down
10 seconds after Overnight mode is set. To reactivate the
LEDs and illuminate the control panel, touch any button
on the control panel or the remote control.
■ Fan Only—Only the fan runs. Press FAN SPEED to select
Low, Medium or High. The Bar LED shows 1 bar for Low,
2 bars for Medium and 3 bars for High fan speed. The
temperature display shows “1” for Low, “2” for Medium
and “3” for High fan speed. After 5 seconds, the display
shows the current room temperature.
NOTES:
■ Auto fan speed and Temperature cannot be selected
in Fan Only mode.
■ In Eco (on some models) and Cool modes, Auto fan
speed is selected automatically.
NOTE: Your model may differ from the one shown.
NOTE: After 5 seconds, display will show the current room
temperature.
Fan Speed
1. Press FAN SPEED until you see the Bar LED display for the
desired setting.
2. Choose High, Med, Low or Auto.
■ Low—Low cooling—1 bar and “1” shows in the
temperature display
■ Med—Normal cooling—2 bars and “2” shows in the
temperature display
■ High—Maximum cooling—3 bars and “3” shows in the
temperature display
■ Auto—Automatically controls the fan speed depending on
the current room temperature and temperature control
setting. “A” shows in the temperature display and 1, 2 or
3 bars display the current fan speed.
NOTES:
■ Auto fan speed and Temperature cannot be selected
in Fan Only mode.
■ In Eco (on some models) and Cool modes, Auto fan
speed is selected automatically.
■ In Overnight (on some models), Low fan speed is
selected automatically.
NOTE: After 5 seconds, the display will show the current room
temperature.
Temperature
■ Press the up arrow button to raise the temperature. Each time
you press or hold the up arrow button, the temperature will go
up 1ºF (1ºC) until it reaches 86°F (30°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
■ Press the down arrow button to lower the temperature. Each
time you press or hold the down arrow button, the
temperature will go down 1ºF (1ºC) until it reaches 61°F
(16°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
To change from Fahrenheit to Celsius
Press and hold the up and down arrow buttons to changed from
Fº to Cº. Release the buttons after Cº turns on.
Modes Cool
Eco
Overnight
Fan Only
C
Hr
AM
Min
PM
AUTO
V
Fan Speed
ROOM: SET:
F
C
HR
AUTO
V
V