Wells WFGA-60FS - Manual (Page 14)

12
B. USING THE FUNCTION KEYS (Item 8)
Halts the time countdown while any menu is running and time remaining is displayed
on the readout.
Purpose: Allows the user to raise the basket to inspect the product in the middle of a cook
cycle. Time remaining is frozen until the PAUSE key is pressed again.
To use: While a menu is running, press and hold the PAUSE key for five seconds, until a
beep sounds and the red indicator lights.
Raise the basket to inspect the product by pressing the BASKET key and UP arrow key.
Resume cooking the product by pressing the BASKET key and the DOWN arrow.
Resume the time countdown py pressing the PAUSE key.
To change the time remaining while in pause:
(a) This option uses the near-instant programming feature of the MENU 7 (MANUAL) key.
Press and hold the TIME key plus the MENU 7 key at the same time.
(b) Scroll in a new time remaining with the UP or DOWN arrow keys. Release all keys.
Press and hold the lit MENU key for three seconds. Display will read “00:00”.
Lower the basket by pressing the BASKET key followed by the DOWN arrow key.
Press the MANUAL (MENU 7) key. The basket will rise when the display reads “00:00”.
If the original menu time or temperature must be asjusted, see TO PROGRAM TIMES
AND TEMPERATURES, page 11.
Puts the fryer into the cleaning mode by setting the temperature to approximately
200ºF (94ºC) (i.e. just below the boiling point of water).
To Use: See CLEANING INSTRUCTIONS, page 21.
Puts the fryer into a “standby” mode for off-peak periods when the fryer is not needed,
but when it is not desirable to perform a complete oil cool down.
Purpose: This economy function allows the oil temperature to cool to 275ºF (135ºC) when the
fryer is not in use, but it is not desirable to turn the fryer off.
To use: While no menu is running and the display reads “00:00”, press and hold the
STANDBY key until a “beep” sounds and the red indicator lights.
To resume cooking after being in standby mode: Press and hold the STANDBY until a
“beep” sounds. The burners will be energized. Fryer is ready for use when the READY
light is lit.
Pressing this allows the UP and DOWN arrow keys to raise or lower the basket.
To Use: Press and release the BASKET key. The red indicator over the basket key will light.
Press and release either arrow key. The indicator for the selected arrow key will light. All
keys will be inactive for the ten seconds of the raise/lower cycle.
This key is only active in the pre-heat and pause modes, or when “00:00” is displayed.
Acknowledges a filter alarm. The filter alarm is programed to sound after a pre-set
number of cook cycles. This is factory pre-set to zero cycles. Your fryer installer
can alter the number of cycles upon request.
To Use: When the cycle count reaches the pre-set number, a “beep” will sound. Press and
release the FILTER key to cancel the alarm and reset the filter load counter to “zero”.
See FILTERING OIL, page 17.
PAUSE
CLEAN
STANDBY
BASKET
FILTER