Weider 831.150311 - Manual (Page 10)

10
The weight bench is designed to be used with your own weight set (not included). The steps below explain how
the weight bench can be adjusted. See EXERCISE GUIDELINES on page 12 for important exercise information
and refer to the accompanying exercise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time the weight bench is used. Replace any worn parts immediate-
ly. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
ADJUSTING THE BACKREST
The Backrest (13) can be used in a decline position,
a level position, or an incline position. To use the
Backrest in the decline position, remove the
Adjustment Pin (25) and lay the Backrest on the
Crossbar (4).
To use the Backrest (13) in the level or incline posi-
tion, lift the Backrest and insert the Adjustment Pin
(25) through the Bench Frame (1) and a hole in the
Backrest Bracket (10). Engage the top hole for a level
position, or one of the other holes for an incline posi-
tion.
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (3), slide the desired weights
(not included) onto the Weight Tube (16). Secure the
weights with a Weight Clip (53 or 54).
Weights can be added to the Curl Bar (not shown) in
the same manner. Secure the weights to the Curl Bar
with two Weight Clips (53 or 54).
Weights can be stored on the tubes on the Uprights
(not shown).
ADJUSTING THE WEIGHT RESTS
To change the height of the Weight Rests (9), remove
the Weight Rest Knobs (23). Position the Weight
Rests at the desired height in the Uprights (8, 7 [not
shown]) and secure them with the Weight Rest Knobs.
4
25
10
8
16
53
Weight
13
1
9
23
3
WARNING:
Do not place more than
150 pounds on the Leg Lever (3) or the Curl Bar
(not shown). Only use the Weight Clips (53 or
54) provided with the bench.
WARNING:
Always set both Weight
Rests (9) at the same height. Make sure the
Weight Rest Knobs (23) are inserted into both
the Upright (7 or 8) and the Weight Rest.
ADJUSTMENTS