Yamaha X-V2600 - Manual (Page 113)

109
REMOTE CONTROL FEATURES
AD
V
A
N
C
ED
OPERA
T
ION
You can change the name of the input source that appears
in the display window on the remote control if you want to
use a different name than the factory preset. This is useful
when you have set the input selector to control a different
component.
1
Set AMP/SOURCE/TV to AMP or SOURCE.
2
Press an input selector button to select the
source component you want to rename.
The selected component name appears in the display
window.
3
Press RE-NAME using a ballpoint pen or
similar object.
If you do not complete each of the following steps within 30
seconds, the renaming mode will be automatically canceled.
In this case, press RE-NAME again.
4
Press k / n to select and enter a character.
Pressing n changes the character as follows:
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),
/ (slash), and space.
(Pressing k changes the characters in reverse order.)
5
Press l / h to move the cursor to the next
position.
6
Press ENTER to set the new name.
OK appears in the display window if renaming was
successful.
NG appears in the display window if renaming was
unsuccessful. In this case, start over from step 4.
y
If you continuously want to rename another component,
press the input selector button or SELECT k / n to select
the component and then repeat steps 4 through 6.
7
Press RE-NAME again to exit the renaming
mode.
ERROR appears in the display window if you press a button not
indicated in the respective step, or when you press more than one
button simultaneously.
Using RE-NAME
Note
AMP
SOURCE
TV
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
SLEEP AUDIO SEL A XM
(U.S.A. model)
RE-NAME
A-E/CAT.
ENTER
PRESET/CH
Note
A-E/CAT.
ENTER
PRESET/CH
RE-NAME