Yamaha POCKETRAK 2G - Manual (Page 13)

Recording
POCKETRAK 2G Reference Manual
13
Selecting the microphone sensitivity
With MIC ALC “ON”:
1. While the recorder is stopped, press the MENU/STOP button for at least two
(2) seconds.
2.
Press the Y or T button to select “VOICE”, then press the W button.
3. Press the Y or T button to select “MIC SENS.”, then
press the W button.
4.
Press the Y or T button to select “HIGH”, “MIDDLE” or
“LOW”, then press the W button.
HIGH: High sensitivity
MIDDLE: Middle sensitivity
LOW: Low sensitivity
5. Press the MENU/STOP button twice to exit from the menu setting mode.
The setting of the microphone sensitivity is complete.
6.
Press the PAUSE/REC button to start recording.
With MIC ALC “OFF”:
1.
Press the PAUSE/REC button to enter the recording
standby mode.
Adjust the angle of the built-in microphones toward the
sound to be recorded.
2.
Press the Y or T button to adjust the microphone sensi-
tivity while checking the level meter.
The microphone sensitivity can be adjusted to 31 levels (Level
0 to level 30).
3.
Press the PAUSE/REC button to start recording.
Note:
· The LCD screen changes while you adjust the microphone sensitivity as shown below.
· The recorder will remember the specified microphone sensitivity for the next recording
session.
· Adjusting the microphone sensitivity during recording may cause unwanted noise to be
recorded. Adjust the sensitivity only when the recorder is in recording standby mode.
SP 20 MIC
SP 15 MIC
SP 20 MIC SP 20 MIC SP 15 MIC