Xerox 96 - Manual (Page 24)

SYSTEM OVERVIEW
1-12 XEROX DOCUPRINT 96/4635/180 IPS SYSTEM OVERVIEW GUIDE
IOCA Replicate and Trim
The IPS also supports Replicate and Trim, which improves the
processing of IM and IO images that contain large areas of shaded
graphics. (IM images are resolution-dependent images that cannot
be compressed or scaled; IO images are resolution-independent.)
The IOCA Replicate and Trim capability allows for faster
transmission to the printer of AFP applications with IM images that
have large or widespread shaded areas. It also reduces the storage
area required on the host and on the printer.
Mixed plex
The IPS allows switching between plex modes (simplex to duplex
and vice versa) within and between jobs without shutting down the
printer.
Switching of plex modes occurs as follows:
•
From simplex to duplex: The switch is done without a printer
shutdown or dead cycles.
• From duplex to simplex: The switch is done without a printer
shutdown. However, the printer may, if necessary, dead cycle to
clear the paper path of all duplex sheets before feeding the first
simplex sheet.
Users can avoid switching from duplex to simplex mode (and thus,
avoid the dead cycles) by using the Maximum Simplex GUI panel to
perform simulated simplex. For more details, refer to the “Setting the
system configuration” chapter in the Xerox DocuPrint 96/4635/180
IPS Guide to Configuring and Managing the System.
Note: When you print simplex pages in duplex mode, the
throughput speed is halved. The blank back pages of the simulated
simplex sheets are counted as billable pages by the system’s
meter.