ZyXEL Communications G-2000 Plus - Manual (Page 354)

ZyAIR G-2000 Plus User’s Guide
353 Chapter 34 Firmware and Configuration File Maintenance
Figure 199 FTP Session Example
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit
34.2.3 GUI-based FTP Clients
The following table describes some of the commands that you may see in third party FTP
clients.
Table 120 General Commands for Third Party FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the server for
anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Initial Remote
Directory
Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).
34.2.4 TFTP and FTP over WAN Management Limitations
TFTP, FTP and Telnet over WAN will not work when:
1 You have disabled Telnet service in menu 24.11.
2 You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet
service.
3 The IP address in the Secured Client IP field in menu 24.11 does not match the client IP.
If it does not match, the ZyAIR will disconnect the Telnet session immediately.
4 You have an SMT console session running.