Z Microsystems 21 - Manual (Page 9)

Doc# 27-0017UM Issued 08/03 Rev 1.0
9
INSTALLATION
INSTALL THE GLIDER IN CABINET FRAME
The Glider slides should
move in and out easily.
If not, check alignment of
the slider and Z-Lock
mount.
Pull the two Glider slides
out until they lock. Hold the Glider on each
side over the back set of
rollers, with the front into
your stomach. The
Glider MUST be level.
This step may best be
done with two people,
one on each side of the
slide rails.
If the Glider binds during
insertion, the Glider
rollers are not properly
aligned into the slider
recepticle.
Simultaneously press in
the catches on each
slider and move the
Glider all the way into
the cabinet frame.
Feed the cables from
the Glider back through
the cabinet frame.
Guide the Glider into the
slides and slide the
Glider in until it stops.
If aligned properly, the
rollers on the Glider slide
smoothly into and out of
the slider rails.