Zenoah CHT2200 - Manual (Page 24)

24
7. Operation
English
■ STARTING ENGINE
Keep the blades clear of the surrounding as they
will start moving upon starting of the engine.
1. When first starting up after putting fuel into the
machine, push the priming pump until fuel runs out
in the clear tube. Then close the choke. Choking
may not be necessary when re-starting right after
stopping the engine.
(1) primer pump
(2) choke lever
(3) CLOSE
(4) OPEN
2. Pull the throttle lever and push the lock button to set
the lever in the START position.
(1) throttle lever
(2) lock buttom
3. Slide the ignition switch to the engine side to set it in
the ON position.
4. Rest the unit on a firm place. Pull the starter knob
quickly.
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
5. When the engine has started, gradually open the
choke.
6. Allow the engine to warm up for a half minute before
starting operation.
• If the engine won't start after several attempts, open
the choke and repeat pulling the rope or remove the
spark plug and dry it.
NOTE
NOTE
WARNING
OP4
OP1
OP2
OP3