ZyXEL Communications Omni 56K II - Manual (Page 76)

Omni 56K II and Omni 56K Plus II User’s Guide
5-30 Command Sets
COMMAND BIT DEC HEX FUNCTION AND DESCRIPTION REF.
32 20 ATX4 X4
40 28 ATX5, error control result code is enabled (default). X5
48 30 ATX6, error control result code is enabled. X6
56 38 ATX7, error control result code is enabled. X7
6 0 0 Displays the result code in numeric format (see
S35.7). V0
64 40 Displays the result code in verbose format (default). V1
7 0 0 The modem returns the result code (default). Q0
128 80 The modem does not return the result code (see also
S40.1). Q1
bit dec hex Bit-mapped register. S24=
6-4 16-
112
10-70 Speaker volume control, increments of 16 in decimal
value. L0-3
S25= 0 to
255
0-FF Specify the time delay that the DTR signal needs to be
OFF before it is recognized, in 10 ms units. If S25=0,
the delay time is set to 4 ms. +000
dec hex RTS/CTS delay. +000 S26=
0 to
255
0-FF Set the delay, in 10 millisecond units between the RTS
and the modem's CTS response in synchronous mode
(see '&Rn' command). &Rn
bit dec hex Bit-mapped register. +156
0-2 Modem error control.
0 0 No error control. &K0
1 1 MNP4 + MNP3 (see also S41.0). &K1
2 2 MNP4 + MNP5 (see also S38.5, S41.0). &K2
3 3 V.42+MNP4 &K3
4 4 V.42 + V.42bis (compatible with &K2) (default). &K4*
3-5 0 0 Flow control disabled
24 18 Hardware (RTS/CTS) flow control (default)
S27=
32 20 Software (RTS/CTS) flow control