Yamaha EMX68s - Manual (Page 20)

18
Connections
EMX88S/EMX68S—Owner’s Manual
■ When the power amp select switch is set to MAIN (L+R) BRIDGE:
• Bridge connection
Connect only one 8–16 ohm speaker to the BRIDGE jack. The speaker will output the combined signal of the
MAIN L bus + R bus. A maximum output of 800 W will be obtained when an 8-ohm speaker is used.
■ Connecting a monitor speaker
You can connect a powered speaker to the MONITOR jack.
Caution:
When using two-channel connection or two-channel parallel connection, do not connect a speaker to the
BRIDGE jack.
When using a bridge connection, do not connect a speaker to either the A or B jacks.
The BRIDGE jack has a protective cap that prevents a speaker from being accidentally connected to it when
you are using two-channel or two-channel parallel connections. Remove this protective cap only when mak-
ing a bridge connection.
8
Ω
–16
Ω
Power amp select switch
Not used Not used
Powered monitor
VOL