Yamaha CVP-109 EN - Manual (Page 155)

155
CVP-109/107/105/700
■ Changing the Voice Selection
...........................................................
• You can select a different voice in the
same bank as the currently selected
voice using a single Program Change
event.
• To select a voice in a different bank, the
Program Change event must be pre-
ceded by two Control Change events
(see the preceding operation) setting the
Bank-M and Bank-L controllers.
• See the voice list on page 3 of the Refer-
ence Booklet to determine the bank and
program numbers for the desired voice.
Select the Program Change event you want to edit in the event list
for the appropriate track ( 1 1 1 1 1 through 16).
➔ The P.CHG NUMBER function is displayed above the fourth
LCD button.
➾ Use the P.CHG NUMBER button to select the Program Change
Number parameter, then use the data dial or the [–] and [+] but-
tons to change the Program Change Number.
P.CHG NUMBER
function
Program Number
Range: 0 — 127
■ Bending the Pitch
...........................................................................................
Pitch Bend Data
Range: –8192 — +8191
Pitch Bend Range
The actual amount by which the pitch is
bent depends on the BEND RANGE value
set in the FUNCTION [PEDAL] display
(page 191) when song data is recorded.
Select the Pitch Bend event you want to edit in the event list for the
appropriate track (1 through 16).
➔ The DATA function is displayed above the fourth LCD button.
➾ Use the DATA button to select the pitch bend data parameter,
then use the data dial or the [–] and [+] buttons to change the
value of this parameter.
DATA function
Program
Change Number
Pitch bend data
153
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Step Edit