Yamaha DSP-AX861SE - Manual (Page 92)

90
En
Advanced setup
■ Speaker impedance
SP IMP.
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8
Ω MIN, 6Ω MIN
• Select “
8Ω MIN” to set the speaker impedance to 8 Ω .
• Select “6
Ω MIN” to set the speaker impedance to 6 Ω .
■ User presets
PRESET
Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 98).
Choices: CANCEL, RESET
• Select “CANCEL” not to reset any parameters of this
unit.
• Select “RESET” to reset the parameters of this unit.
• This setting completely resets all the parameters of this unit
including the “SET MENU” parameters.
• The initial factory settings are activated next time you turn on
this unit.
■ Remote control AMP ID
REMOTE AMP
Use this feature to set the AMP ID of this unit for remote
control recognition. This feature is useful when you
operate this unit and the other Yamaha receivers/
amplifiers in the same room separately.
Choices: ID1, ID2
• Select “ID1” when the remote control AMP ID code is
set to “2001”.
• Select “ID2” when the remote control AMP ID code is
set to “2002”.
Setting remote control AMP ID codes
You need to set the remote control AMP ID code for the
remote control.
1
Set the operation mode selector to L
AMP or
L
SOURCE.
2
Press and hold T
LEARN for about 3
seconds using a ballpoint pen or similar
object and then press
D l / h repeatedly
until “L;AMP” appears in the display window
(
J ) on the remote control.
• Be sure to press and hold TLEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3
Press D
ENTER.
The four-digit code set for the selected input area
appears in the display window (
J ) on the remote
control.
See page 89 for the operation of the advanced setup.
SP IMP. Speaker Impedance level
8Ω MIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 8
Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16
Ω or
higher. *
Center
The impedance of each
speaker must be 8
Ω or
higher.
Surround
Surround back
6
Ω MIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 4
Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8
Ω or
higher.
Center
The impedance of each
speaker must be 6
Ω or
higher.
Surround
Surround back
Notes
Notes
LEARN
ENTER
A/B/C/D/E
PRESET/CH