Yamaha M7CL-32 - Manual (Page 93)

Operations in the SELECTED CHANNEL section
M7CL Owner’s Manual
Oper
ations in the SELECTED CHANNEL section
7
93
●
Making HA settings
(input channels only)
To control the head amp (HA) assigned to an INPUT/ST
IN channel, you will use the [HA] encoder of the
SELECTED CHANNEL section and the HA field of the
SELECTED CHANNEL VIEW screen. The HA field
includes the following items.
1 GAIN knob
This indicates the gain of the head amp assigned to the
channel. To adjust the value, use the [HA] encoder of
the SELECTED CHANNEL section.
B INPUT PORT popup button
This shows the input port assigned to this channel. It
also accesses a popup window in which you can select
the input port.
C +48V
This indicates the phantom power on (red) or off
(black) status for the head amp assigned to the chan-
nel.
D ø (Phase)
This indicates either normal phase (black) or reverse
phase (orange) for the input assigned to the channel.
E OVER indicator
This will light when the input signal from the HA
reaches the overload point.
To adjust the head amp gain, use the [HA] encoder of the
SELECTED CHANNEL section.
When you press the GAIN knob in the screen, the HA/
PATCH popup window (1 ch) will appear, allowing you to
make settings for the head amp. (For details on the popup
window
→ p. 61). When you press the INPUT PORT but-
ton, the PATCH/NAME popup window will appear, allow-
ing you to select the input port for each channel. (For
details on the popup window
→
p. 108).
●
Setting the pan/balance
To adjust the pan/balance of the signal sent from that
channel to the STEREO bus, use the [PAN] encoder of the
SELECTED CHANNEL section and the TO ST PAN/
BALANCE field of the SELECTED CHANNEL VIEW
screen. The TO ST PAN/BALANCE field includes the fol-
lowing items.
1 PAN/BALANCE knob
The following parameter will change, according to the
channel that is selected.
B ST/MONO button
(INPUT, ST IN, and MIX channels only)
This switches the on/off status of the signal sent from
that channel to the STEREO (L/R) bus and MONO
(C) bus.
C LCR button
(INPUT, ST IN, MIX channels only)
If an INPUT, ST IN, or MIX channel is set to LCR
mode, the LCR button is displayed in location (
2 ).
The LCR button is an overall on/off switch for the sig-
nals sent from the channel to the STEREO bus and
MONO bus.
To adjust the pan/balance of each channel, use the ST/
MONO button or LCR button to select the send-destina-
tion bus, and operate the [PAN] encoder of the
SELECTED CHANNEL section.
1 2
3 4
5
• The PAD will be internally switched on or off when the HA gain is
adjusted between -14 dB and -13 dB. Keep in mind that noise may
be generated if there is a difference between the Hot and Cold
output impedance of the external device connected to the INPUT
connector when using phantom power.
NOTE
INPUT channel TO STEREO PAN
ST IN channel TO STEREO BALANCE
MIX (MONO × 2) channel TO STEREO PAN
MIX (STEREO) channel MIX BALANCE
MATRIX (MONO × 2) channel Not displayed
MATRIX (STEREO) channel MATRIX BALANCE
STEREO channel STEREO BALANCE
MONO channel Not displayed
1 2
3