ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite - Manual (Page 47)

Omni.Net Lite User’s Guide
Chapter 2 Using the Utility 46
The following table describes the labels in this screen.
2.12 Voice Calls
This section covers how to initiate and receive calls over an ISDN through the analog ports on
your ISDN TA and introduces supplementary services including call hold, call waiting, call
transfer and three-way conference.
Note: You can only use the utility, AT command or Tone command to activate or
deactivate call waiting. Use the flash key and the digit keys on the telephone to
invoke supplementary services (see
Section 2.12.4 on page 47 ).
2.12.1 Placing a Voice Call
You can use your analog phone connected to the PHONE 1 and PHONE 2 ports to dial out a
call directly. With the Quick Dial feature, you can place an ISDN voice call by dialing “nn#”
(where nn=00-04, pre-stored phone number index). You must store up to five phone numbers
first by using the utility, AT commands or tone commands. Refer to
Section 2.9 on page 40 on
how to store a phone number with the utility.
Table 10 Analog Port: Local DN and Options
LABEL DESCRIPTION
Local Directory Number
Port 1
Port 2 Enter the ISDN phone number for voice calls in the Address field and the sub-
address in the SubAddress field.
CLIP and CLIR
Selection
CLIP (Calling Line Identity Presentation) displays the phone number of the
caller on the callee’s telephone. CLIR (Calling Line Identity Restriction) allows
the phone number to be hid.
Select CLIP (pass self DN to destination site) to allow the ISDN switch to
pass your phone number to the destination site.
Select CLIR (don’t pass self DN to destination site) and the CLIP service
will not be available.
Device type on analog
port
To enable the Type 2 service on either analog port, select Telephone with
Call Waiting caller ID device.
Otherwise, select Telephone, G3 Fax or Modem.
Port Priority To set the same priority for both two ports, select Port priority to Both ports
are same priority.
To set the PHONE 1 port to have the first priority, select Port priority to
Analog Port 1 is high priority.
To set the PHONE 2 port to have the first priority, select Port priority to
Analog Port 2 is high priority.
Dialing method Configure how to send the signaling message with the phone number. Options
are OVERLAP sending and EN-BLOC sending.