STIEBEL ELTRON SBP E с 01.10.2012 - Manual (Page 12)

12 | SBP E | SBP E SOL | SBP E cool www.stiebel-eltron.com
InStaLLatIOn
Safety
InStaLLatIOn
4. safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
4.1 general safety instructions
We only guarantee trouble-free function and operational reliability
if the original accessories and spare parts intended for the
appliance are used.
5. appliance description
5.1 standard delivery
The standard delivery includes the following parts.
- Adjustable feet (only with SBP 200 E | SBP 400 E)
5.2 accessories
- immersion heater
- compact installation
6. installation
6.1 installation site
f f Ensure the floor has a sufficient load bearing capacity (see
chapter “Specification / Data table”).
f f Check the height of the room (see chapter “Specification /
Data table”).
6.2 transport
!
Material losses
We recommend removing the cylinder casing during
transportation to the installation location.
6.2.1 Removing the cylinder casing
3
1
2
26
�0
3�
20
�0
16
1
1 Lid
2 Cylinder casing
3 Plinth fascia
f f First remove the lid and then the plinth fascia.
6.2.2 sBP 700 e | sBP 700 e sol
These appliances have side insulation sections that can be
removed. This will make transportation through narrow doors
and passageways easier.
f f Remove the retaining straps by opening the closures.
When reattaching the retaining straps, ensure that the closures
are near a joint between the casing parts.
6.3 Positioning
6.3.1 sBP 200 | sBP 400
f f Fit the adjustable feet provided, these are already fitted on
SBP E cool appliances.
f f Use the adjustable feet to compensate for any unevenness in
the floor.
6.3.2 sBP 700
These appliances do not have adjustable feet. The floor must be
level.