FIAT Panda User Manual
Page 146
❒ fit handle D fig. 104 into the housing in device A,
operate the jack and raise the car until the wheel
is a few centimetres from the ground;
❒ remove the wheel cap after loosening the 3 fixing
bolts and finally loosen the fourth bolt and extract
the wheel (only for versions with wheel caps
fixed by bolts);
❒ make sure the contact surfaces between
space-saver wheel and hub are clean so that the
fastening bolts will not come loose;
❒ fit the space-saver wheel by inserting the first bolt
for two threads into the hole closest to the valve;
❒ take the wrench A fig. 103 and fully tighten the
fixing bolts;
❒ operate the jack handle D to lower the car. Then
extract the jack;
❒ use the wrench A provided to fully tighten the
bolts in a criss-cross fashion as per the numerical
sequence illustrated in fig. 106;
❒ when replacing an alloy wheel it is advisable to
place it upside down, with the aesthetic part facing
upwards.
fig. 103
F0W0179
fig. 104
F0W0025
fig. 105
F0W0024
142
GETTINGTO KNOW
YOURCAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX