FIAT Panda Classic - Manual (Page 110)

Assembly diagram fig. 3
The tow hook structure must be fastened
in the points shown by letters “a-b-c-d”
using a total of 4 M10 screws.
The hook should be fastened to the body
avoiding any type of drilling and trimming
of the rear bumpers that remains visible
when the hook is removed.
IMPORTANT It is compulsory to fasten a
label (plainly visible) of suitable size and ma-
terial with the following wording:
MAX LOAD ON BALL 60 kg
After fitting, screw holes shall be sealed to
prevent an exhaust gas inlet.
109
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
SAFETY DEVICES
CORRECT USE OF THE CAR
fig. 3 F0G0225m
Rear axle
Full load
Standard tow ball
101-112 Panda New GB 21-06-2007 13:50 Pagina 109