Inspecting and changing fuses, 2011 cr-z – HONDA 2011 CR-Z User Manual
Page 308
307
Handling the Unexpected
Fuses Inspecting and Changing Fuses
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
0
. Turn
headlights and all accessories off.
Check the fuses in the engine
2.
compartment.
If the fuse is blown, have it replaced by
a dealer.
3. Inspect the small fuses in the vehicle
interior.
If there is a burned out fuse, remove it
with the fuse puller and replace it with
a new one.
Fuse
Blown
Inspecting and Changing Fuses
NOTICE
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system. If you do not have a replacement
fuse with the proper rating for the circuit, install
one with a lower rating.
Replace fuse with a spare fuse of the same
specified amperage.
Confirm the specified amperage using the charts
on
There is a fuse puller on the interior fuse box.
Fuse Puller
31SZT600book.indb 307
2010/04/28 13:44:47
2011 CR-Z