EVS EPSIO Version 1.63 - May 2011 User's Manual - Manual (Page 12)

Issue 1.63.C Epsio Version 1.63 – User’s Manual
EVS Broadcast Equipment – May 2011
6
# Icon Description
1. Check that the received blackburst signal corresponds to the video
format selected in the Epsio Configurator.
Depending on whether the received signal corresponds to the
specified video format or not, the following information will be
displayed:
• NO SYNC
• SYNC OK
• WRONG SYNC
The values between brackets show the requested format, based on
the format defined in the Epsio Configurator, and can be one of the
following:
• BB PAL
• BB NSTC
• Tri-Level 1080i50
• Tri-Level 1080i60
• Tri-Level 720p50
• Tri-Level 720p60
2. Check that the Epsio IN1 connector correctly receives the video
signal from the EVS server in the specified video format.
3. Check that the Epsio IN2 connector correctly receives from the EVS
server or a camera in the specified video format.
4. Epsio and EVS server IP addresses
Time when the last command was executed on the server.
You need to press SHIFT+D when you open Epsio and enter the
Epsio menu on the Remote Panel to force the system to check the
communication via the Ethernet network, and confirm the connection.
In the course of operations, the icon will not automatically turn red if
you lose the connection. You need to recheck the communication by
entering again the Epsio menu on the Remote Panel.
5. Information on whether the animation is visible or not.