Herman Miller Mirra Chairs - Disassembly For Recycling - Manual (Page 10)

Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Mirra, Co/Struc and Embody are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, Tu and SAYL are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products. 10
Z Part no. 1b9rtg rev B.
35. Pull up on hinged top at
center, to disengage retaining
loops and open hinged top.
If required.
36. Using small flat blade
screwdriver, loosen both “S”
clips. Make sure “S” clips stay
in place on tilt housing.
If required.
37. Grasp front cover along
lower edge, near pneumatic
cylinder. Pull front cover forward
to remove.
34. Remove rear tilt limit
handle from tilt assembly.