High Lifter DynoJet Jet Kit for Yamaha Wolverine 350 (96-05) User Manual
Page 2
STAGE ONE INSTRUCTIONS
1. Remove vacuum slide from the carb. Remove stock needle & spacers, noting order of assembly.
2. Locate the slide lift hole (Fig. A). Use the (DD32) drill provided to enlarge slide lift hole (Fig. A).
3. Install Dynojet needle on groove #4 for applications below 5000 feet, groove #3 for above 5000 feet, using
all stock spacers. Install the Dynojet washer above the E-clip.
4. Remove the stock main jet and replace withthe Dynojet main jet provided. When using the stock exhaust
use, the DJ155 below 3000 feet, DJ150 from 3000 to 6000 feet and DJ144 above 6000 feet. When using an
aftermarket exhaust, use the DJ160 below 3000 feet, DJ155 from 3000 to 6000 feet and DJ150 above 6000
feet. Be sure that the jet you are changing is the main jet (Fig. B).
5. Locate the Fuel Mixture Screw(Fig. B). Using a flat blade screwdriver, turn the mixture screw clockwise
until it seats, then turn out 2 1/2 turns.
Fig.A
Q403.001
This is Groove # 1
Fig.B
Dynojet Parts
Stock Parts
Mixture Screw Location
Main Jet Location
Slide Lift Hole