MSD 6201 Digital 6A Ignition Control - Manual (Page 12)

12 INSTALLATION INSTRUCTIONS
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
COIL
WIRE
A
(PINK)
WIRE
A
(PINK)
WIRES
B AND C
WIRES
B AND C
FACTORY HARNESS
(CUT FROM COIL)
BLACK (COIL -)
ORANGE (COIL +)
MAGNETIC PICKUP
(NOT USED)
GRAY
TACH OUTPUT
GREEN (-) VIOLET (+)
RED
WHITE
INDICATES CONNECTION
•
DIGITAL 6AL
REV
LIMITER
GM IGNITIONS Wiring the 1996 and up single connector coil without harness.
NOTE: MSD offers a direct plug in harness,
PN 8877, that makes this a splice
free installation.
NOTE: The coil connector is labeled A-B-C.
The wire in the A port is positive
(pink). The wires in B and C are coil
negative wires, color will vary by
application.
WIRE
A
(PINK)
WIRES
B AND C
WIRES
B AND C
FACTORY HARNESS
(CUT FROM COIL)
BLACK (COIL -)
ORANGE (COIL +)
MAGNETIC PICKUP
(NOT USED)
GRAY
TACH OUTPUT
GREEN (-) VIOLET (+)
RED
WHITE
INDICATES CONNECTION
•
DIGITAL 6AL
REV
LIMITER
GM IGNITIONS Wiring a Dual Connector Coil.
NOTE: Cut and splice the two pink wires
(coil positive) together and connect
to orange wire of MSD. Cut and
splice the two white wires (coil
negative) together and connect to
the white of MSD. If the vehicle is not
equipped with a factory tach, there
will only be one white wire.
NOTE: MSD offers a direct plug in harness, PN 8876, for this coil.