MSD 8732 2-Step Rev Control for Digital 6AL Installation - Manual (Page 2)

2 INSTALLATION INSTRUCTIONS
M S D I G N I T I O N
• W W W . M S D I G N I T I O N . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
WIRING
MOUNTING
It is suggested to mount the unit within easy reach for adjustments. The Control can be mounted
under the hood but should be away from direct engine heat sources. Make sure the wiring reaches the
connections and mark the mounting holes. Use an 1/8” bit to drill mounting holes and mount the unit.
WIRING
Red Power. Connect to a switched 12 volts.
Black Ground. Connect to ground.
Blue Launch RPM Activation wire. When connected to 12 volts the launch rpm value is active.
Gray Tach Signal. Connect to the Gray Tach Output wire of the MSD PN 6425.
Figure 2 Wiring the Control with an MSD Digital 6AL Ignition Control.
GREEN VIOLET
DISTRIBUTOR
ORANGE
BLACK
GRAY
GRAY
RED
12 VOLTS
RED
WHITE
POINTS/AMPLIFIER
MAGNETIC PICKUP
12 VOLTS IGNITION KEY
DIGITAL 6AL
REV
LIMITER
BLACK
TO GROUND
OR
SWITCH OR
MICRO SWITCH
PN 8820
TO 12V
BLUE
TO LINE LOCK
OR TRANS-BRAKE
SOLENOID
TACH
OUTPUT
X1000 X100