Naxa NPB-428 - Manual (Page 5)

4
AM BAND
Select AM mode by band selector switch. Turn the TUNING control to select the desired station. For
AM reception, the set is controlled by a built-in ferrite aerial which is directional. Therefore, the set
should be positioned for the best signal strength.
LOADING THE BATTERIES INTO THE REMOTE HANDSET
 Open the battery compartment cover.
 Insert two “AAA” batteries (not included) as indicated inside the battery compartment.
 Close the cover.
KEY FUNCTIONS:
1. CD PLAY/PAUSE BUTTON
2. CD SKIP FORWARD BUTTON
3. CD STOP BUTTON
4. +10 MP3 BUTTON
5. CD SKIP BACKWARD BUTTON
6. CD/USB BUTTON
7. PROG./P-MODE BUTTON
8. BATTERY COMPARTMENT
REMOTE CONTROL OPERATION
To operate the unit with the remote control, point the remote
handset at the remote sensor on the front panel and press the
appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from the
front panel and on an angle of 30 degrees. Bright sunlight or
room light conditions can interfere with the remote control. If
the remote operation is unsatisfactory or stops working entirely,
first try replacing the remote batteries, then try reducing the
room lighting conditions.
CASSETTE OPERATION
PLAYBACK OF CASSETTE
Be sure to tighten any slack tape in the cassette before use, using either a pencil or a ballpoint pen,
simply insert the pen or pencil into the center of spool and rotate to remove slacks. Depress the
STOP/EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing upwards and the full reel on the left
hand side, push the cassette well down and close the door, be sure not to touch the tape surface, Set the
Function switch to “TAPE” position and press the cassette play button. To stop playback, press the
STOP/EJECT button once. To release the cassette, press the STOP/EJECT button again.
AUTO STOP
When the tape reaches the end during playback or recording, the built-in auto stop system will release
the depressed play, record keys. The auto stop system operates while recording from the built-in radio or
CD player, only the cassette function is brought automatically to stop mode and the radio or CD Player
will continue to play.