VEGA VEGACAP 62 - two-wire - Manual (Page 16)

16
5 Connecting to power supply
VEGACAP 62 • - two-wire
30007-EN-130916
Fig. 8: Connection steps 5 and 6
6. Insert the wire ends into the open terminals according to the wir-
ing plan
7. Press down the opening levers of the terminals, you will hear the
terminal spring closing
8. Check the hold of the wires in the terminals by lightly pulling on
them
9. Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10. If necessary, carry out a fresh adjustment
11. Screw the housing cover back on
The electrical connection is hence finished.
5.3 Wiring plan, single chamber housing
1
4 4 4
2 3
Fig. 9: Material versions, single chamber housing
1 Plastic (not with dust-Ex)
2 Aluminium
3 Stainless steel
4 Filter element for pressure compensation or blind plug with version IP 66/
IP 68, 1 bar
Housing overview