Velleman NVR3 - Manual (Page 4)

NVR3
V. 01 – 07/08/2013 4 ©Velleman nv
GUI (Graphical User Interface) display and USB mouse
high compatibility and offsite backup:
o
compatible with all major IP cameras that are ONVIF certified
o works with free Central Management System (CMS) software for offsite backup
local and remote control completely independent
HDMI video output resolution up to 1080P
automatic integrated Dynamic Domain Name Service (DDNS): free service
optional monitor: MONSCA8
o
adapter: PAC916T
o HDMI cable: PAC400Tx series and PAC400Gx series
optional hard disk: HD500GB/S, HD1TB/S, HD2TB/S
USB mouse: incl.
IR remote control: incl.
suitable IP cameras: CAMIP11, CAMIP12, CAMIP16
optional router: EM4544, EM4543, EM4571, PCRT1.
5. Installing the Hard Disk Drive (HDD)
Notes:
It is not recommended to use a green hard disk in this device. For a list of compatible hard disks, please
refer to the appendices in the full user manual.
It is recommended to clear all data on a new hard disk after the DVR is powered on, and to set the date
and time correctly to make sure that recorded data are not mixed with older data. For details on clearing all
data, refer to the full user manual on the included CD-ROM.
Refer to the illustrations on page 2 of this manual.
1. Obtain a suitable hard disk (not included), type SATA (Serial Advanced Technology Attachment). The hard
disk must be formatted.
2. Make sure to unplug the device from the mains before servicing and do not touch any electronic circuitry
to avoid electrostatic discharge.
3. Loosen the screws on the top cover of the DVR and open it. Locate the hard disk connector [1] and
bracket [2] in the device.
4. Make sure the PCB side of the hard disk is facing down, and insert the hard disk into the hard disk
connector [1].
5. Fasten the hard disk to the bracket [3].
6. When the hard disk is installed, close the top cover and fasten it with the screws.
6. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
ALARM
LED indicator: an alarm event occurs
INTERNET
LED indicator: the NVR is connected to internet
RECORD
LED indicator: recording is on
HDD1 LED indicator: hard disk is installed in the NVR and connected well
e-SATA LED indicator: an external disk array is connected
USB port
Insert a compatible USB flash drive for video backup.
Note: For the list of compatible USB flash drives, refer to the full manual on the CD-
ROM.
mouse port
Insert a mouse (included).