SCT-Germany VERGASER REINIGER - Manual (Page 5)

5
Selection of materials derived from glove manufacturer's indications. Final selection of glove
material must be made taking the breakthrough times, permeation rates and degradation into
account. Selection of a suitable glove depends not only on the material but also on other quality
characteristics and varies from manufacturer to manufacturer. In the case of preparations the
resistance of glove materials cannot be calculated in advance so it has to be tested before use. The
exact breakthrough time of the glove material can be requested from the protective glove
manufacturer and must be observed.
8.2.2 Environmental exposure controls
n.av.
9. PHYSICAL AND CHEMICAL PROPERTIES
9.1 General information
Physical
state: Liquid
Colour: Light yellow, clear
Odour: Characteristic
9.2 Important health, safety and environmental information
pH-value undiluted:
n.a
Boiling point/boiling range (°C): 145 °C
Melting point/melting range (°C): Not detected.
Flash Point: (°C): 41 °C
Ignition temperature: 235 °C *
Minimum limit of explosion: 0,6 Vol % *
Maximum limit of explosion: 7,0 Vol % *
Vapour pressure: 3 hPa (20°C) *
Density (g/ml): 0,796 (15°C)
Water solubility: Insoluble
Vapour density (air = 1): Vapours heavier than air.
Viscosity: < 7mm²/sec (40°C)
* Naphtha (petroleum), hydrodesulfurized heavy
10. STABILITY AND REACTIVITY
Conditions to avoid: See point 7 Stable when handled and stored correctly. Heating, open flame,
ignition sources.
Materials to avoid:
See point 7
Avoid contact with strong oxidizing agents.
Hazardous decomposition products:
See point 5.3
No decomposition when used as directed.