Wiring the fault alarm contact – B&B Electronics EIR405-SFP-T - Manual User Manual

Page 8

Advertising
background image

Hardware Installation

5

Manual Document Number EIR-SFP-T-0912m

www.bb-elec.com

www.bb-europe.com

Wiring the Fault Alarm Contact

The fault alarm contact is in the middle of terminal block connector as shown below. If

one of the power sources fails a fault will be detected causing the circuit to open.


Insert the wires into the fault alarm contact (No. 3 & 4)



Note

The wire gauge for the terminal block should be 12 to 24 AWG.

Advertising
See also other documents in the category B&B Electronics Accessories communication: