B&B Electronics APXN-Q5428 - User Manual - Manual (Page 47)

AirborneM2M™ Users Guide B&B Electronics, Inc.
1/9/2014 47
Step Description
Select Tunnel Port Enter the port to be used for the tunnel.
Default is 8023. This should only be changed
if a port is already defined for the application
server or it is already being used by another
service.
Select Tunnel Mode Select TCP from drop down menu.
Press Commit [Button] Saves changes to the device.
Press Reload [Button] Reloads the Connection Settings page.
Feature Link
Select Serial Port Settings
The wireless interface and security must be
configured before configuring the Ethernet
settings.
Displays a page showing the serial port
configuration. You will set the default mode of
operation for the serial interface here.
Select Serial CLI Default Mode Select Listen from the drop down menu.
Press Commit [Button] Saves changes to the device.
Optional
Press Reload [Button]
Reloads the Serial Port Settings page. Select
this if you have further configuration options to
change.
Optional
Press Restart [Button]
Restarts the device. After the device has
rebooted it will attempt to authenticate to the
configured network. As long as the network is
in range the wireless interface will connect.
After authenticated is completed you will be
able to make a TCP/IP connection on the
Telnet port.
To establish a data tunnel and gain access to the serial data from the WLAN or
Ethernet interface follow the steps in Table 24.
Table 24 - Data Tunnel using Tunnel Port on Serial Port 1
Step Description
Open TCP socket to device Using the WLAN IP Address and configured
tunnel port number for Serial Port 1 (Default
8023).
15.3 Configuring Serial Port 2 for Access on Tunnel Port
A data tunnel can be made using the device ’s tunnel port as the network
connection port. This does not require authenticating with the device and
automatically initiates the tunnel connection. Configuring the device to support
this approach is covered in the following table.
Table 25 – Configure Data Tunnel on Serial Port 2 Tunnel Port (TCP)
Step Description
Navigation Bar
Select Configuration
You will see a group of fields under the banner
of WLAN Parameters.