Knape&Vogt PKT-75A Series - Manual (Page 2)

SLIDING DOOR HARDWARE - POCKET DOOR
Hmax = Door Height + 2-1/2" • Hmin = Door Height + 2-1/8"
1
2
3
PREPARE OPENING
mOuNT FRAmE HARDWARE
• Center track in opening.
• To take advantage of the key-holed slots, be sure there
is a 3/4" minimum gap from the finished opening
to the track. If necessary, track may be cut with a fine
tooth saw.
•
ImPORTANT: Place hangers loose into track before
securing.
• Using track as template, mark screw locations.
• Drill 3/32" pilot holes and secure with (#8 x 1") screws.
(F)
• To allow future replacement in the field, the screws
installed through the track to the header in the pocket
side must be backed out one half turn after seating
the track.
mOuNT DOOR HARDWARE
Rough Opening Width = 2 x Door Width + 1"
Assembly
Instructions
#310290_C (1013)
3/8" - 1/2"
(1 cm - 1,3 cm)
3/4" Min.
(1,9 cm)
1-3/4" - 2"
(4,4 cm - 5,1 cm)
• Place top mount plates on top of each
door at the distance shown from the
outside edge.
• Using brackets as a template, drill
3/32" diameter holes and secure
with (#8 x 1") screws.
(F)
• Secure door bumper as shown.
Opening Height
Hauteur Ouverture
Altura Abertura
Door Height
Hauteur Porte
Altura Puerta
Opening Width
Largeur de l’overture
Ancho de la abetura
Center
Centre
Centro
Front
Avant
Delantera
5-1/2"
(14 cm)
Rear
Arriére
Parte trasera
Opening
Hauteur
Altura
Rear
Arriére
Parte trasera
1"
(2,5 cm)
Pocket
Partie
coulissante
escamotable
Cavidad