R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 - Manual (Page 62)

LM10 I&M MANUAL/EN/11.30.2010
62/85
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
8.3 Recommended technical support for various spare parts
Table 7. Recommended Technical Support for Various Spare Parts
SPARE PART REPLACED BY
Upper chain guide
Output shaft
PG cable gland
Gear shaft + nuts
Motor end cap
Gearing (1st/2nd stage)
Brake & end cap sealing
Other seals and O-rings
Brake-limiter
Brake end cap
Lower chain guide
Rubber buffer
Electric box
PC-board
Plugs
Chain
Chain bucket
Slack fall stop
Suspension hook
Hook block assembly
Control box
Qualified Electrician & Mechanic
Qualified Electrician & Mechanic
Qualified Electrician
Qualified Mechanic
Qualified Mechanic
Qualified Electrician & Mechanic
Qualified Mechanic
Qualified Mechanic
Qualified Electrician
Qualified Mechanic
Qualified Mechanic
Qualified Mechanic
Qualified Electrician
Qualified Electrician
Qualified Electrician
Qualified Mechanic
Qualified Mechanic
Qualified Mechanic
Qualified Mechanic
Qualified Mechanic
Qualified Electrician
NOTE: Once a part has been replaced, perform an operational check of hoist per
Sections 3.3 and 3.4.
8.4 Screw Tightening Torque (lb-ft) Specifications
Table 8. Screw Tightening Torque Specifications
TYPE M5 M6 M8 M10 M12
STANDARD SCREWS 4 7 18 35 61
SELF-TAPPING SCREWS 4 6 15 30 53