R&M Materials Handling MANUAL CHAIN HOISTS - Manual (Page 80)

RMLH / RMLHC INSTRUCTION
MANUAL/EN/07.20.10
8/9
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
5.2 DON’TS:
5.2.1 Handling / Storage
Do not put the equipment on anything without suitable support otherwise parts on the underside may
become damaged.
5.2.2 Installation / Maintenance / Servicing
• Never modify the equipment.
•
Never overload the equipment.
5.2.3 During Use
Never attempt to move a load greater than the capacity indicated on the equipment.
Remember that accidental impacts or snagging of the load being handled with surrounding objects
may provoke an overload.
Never side pull the load.
Do not use the equipment for extracting or un-jamming purposes or for lateral pulling etc.
Never use the equipment to transport people.
Keep hands away from moving parts.
Never use the equipment if it is in bad condition (worn, bent, etc.).
Do not use spare parts of unknown or doubtful origin.
Do not provoke violent impacts or shock loads with the equipment.
Do not constantly use the end stops as a means of stopping.
Never use the equipment as a ground for welding.
Do not use the equipment for a purpose or in a situation for which it is not designed.
Do not expose the equipment to an aggressive environment (temperature, acidity, etc).
Do not operate jerkily as this provokes deterioration of the equipment.
Never pull loads sideways; center the equipment above the load before lifting it.
Note: Check that the equipment corresponds to the details on the delivery note attached to the
packaging.