dbx DriveRack PA+ - Manual (Page 31)

6.4 Stereo 2-Way with Mono Sub
Hardware
Connect the outputs from the mixer to the inputs of the DriveRack® PA+. 1.
Connect the outputs of the DriveRack PA+ to the selected speaker amplifier. 2.
Make sure that the mixer and power amps are turned off prior to powering up the 3.
DriveRack PA+.
Front Panel Editing
From Preset mode, select factory preset #27 (Stereo 2-Way) as a template, or use the 1.
Wizard to set up the specific preset.
Once the preset has been chosen, press the Data Wheel to load the preset.
2.
Left Right
Mono Low Left High Right High
Self-Powered
Top Speakers
Section 6
Application Guide
27
DriveRack
®
PA+