Dexter Laundry SWD EXPRESS - Washer (On-Premise) - Manual (Page 10)

Ct ** Tumble Time Two-digit amount of time in minutes.
t ** Water Temperature HH for hot, CH for warm, CC for cold
and EE for no water.
L ** Water Level Lo for low, Hl for high.
dF * Type of Fill d for delayed fill, t for timed fill.
1
S ** Spin Time Two-digit amount of time in minutes.
IS * Injection Source Single digit code indicating injector signal(s).
2
1
A delayed fill will pause the time count until the selected level is reached. A timed fill will
only fill for a predetermined amount of time.
2
Codes for injections sources are defined at the end of the programming section. When the No
Water bath is selected, the electronic controller prohibits injection signals. The programmed
injection source value is ignored.
To exit the programming of a bath, press the “STOP” button once and use the “UP” and “DOWN”
keys select another bath. Press the “STOP” button again to select a different cycle to change. To
end programming, turn the key to “RUN” position
WASHER CYCLE PARAMETER RANGES
The range of each cycle parameter is shown below:
Cycle Time 0 to 15 minutes for Prewash, Wash, Rinse1, 2, 3 and 4
1 to 15 minutes for Final Rinse
For the bathes that can, if the time is set to zero, then the bath
will be eliminated from the cycle.
Water Temperature HH – hot, CH – warm, CC – cold, EE – no water
Water Level
HI – high, LO – low
Delay Fill
The selections are “d” for delay the bath time until water level
is reached or “t” for decrement bath time during the fill.
Spin Time
0 to 10 minutes for Prewash, Wash, Rinse, 2, 3 and 4
1 to 10 minutes for Final Spin
Injection Source 0 to 6
Note: The Wash Cycle programming mode will automatically exit and return to
the Idle mode if no buttons are pushed for one minute.