Factory Direct Hardware Brizo 63052LF Belo - Manual (Page 13)

This faucet includes an integrated
handle limit stop that has two positions.
Position 1, to the left, allows full handle
motion (the full range between “all cold”
to “all hot”). The faucet is set in position
1 in the factory. Position 2, to the right,
allows half of the normal handle motion
(“all cold” to “mixed hot/cold”).
The handle limit stop can be adjusted
by the homeowner once the faucet is
installed. Setting the handle limit stop in
position 2 may help to prevent scalding
Setting The Handle Limit Stop (Optional)
1
2
because it limits the amount of hot water
in the mix; however, this handle limit stop will
not always prevent scalding because it does
not compensate for incoming pressure or
sudden water temperature changes.
To change positions of the handle limit
stop: remove the handle; move the
valve stem to the all cold position so the
water is on; change the position of the
handle limit stop; turn off the water; reinstall
the handle.
7
13