Universal Audio SOLO 610 - Manual (Page 9)

9
(11) THRU Jack – This is an unbalanced ¼” mono “TS” (tip-sleeve) output that carries the same
signal that is put into the DI jack. This port is typically used to send the instrument signal that is
plugged into the DI jack back out to an instrument amplifier or other unbalanced input. The signal at
this jack is unaffected by the rear panel MIC/LINE output level switch.
Rear Panel Descriptions
(12) AC Input – Connect a standard, grounded, detachable IEC power cable (supplied) here.
Note: The power supply is NOT auto-sensing. Changing the AC input from the shipped configuration
requires moving an internal jumper and changing the fuse to avoid damaging the unit.
UNIVERSAL AUDIO, INC. UNIVERSAL AUDIO, INC.
SCOTTS VALLEY, CALIF. USA SCOTTS VALLEY, CALIF. USA
PUSH
12
13
14
15
16 17
18
POWER IN:
100VAC, 50-60Hz
115VAC, 50-60Hz
230VAC, 50-60Hz
FUSE RATING:
100VAC: T300mA 250V
115VAC: T250mA 250V
230VAC: T125mA 250V
REPLACE FUSE WITH PROPER
TYPE AND RATING ONLY
 IMPORTANT: The unit can be damaged if the wrong input voltage is connected. Changing
the AC input from 115 volts to 230 volts (and vice versa) requires moving an internal
jumper and a fuse value swap. See the Maintenance section on page 18 for details.