Asus P5GD2 Premium - Manual (Page 49)

A S U S P 5 G D 2 P r e m i u m A S U S P 5 G D 2 P r e m i u m A S U S P 5 G D 2 P r e m i u m A S U S P 5 G D 2 P r e m i u m A S U S P 5 G D 2 P r e m i u m 2 - 2 5 2 - 2 5 2 - 2 5 2 - 2 5 2 - 2 5
3 . 3 . 3 . 3 . 3 . I D E R A I D c o n n e c t o r s ( 4 0 - 1 p i n P R I _ R A I D 1 [ b l u e ] , I D E R A I D c o n n e c t o r s ( 4 0 - 1 p i n P R I _ R A I D 1 [ b l u e ] , I D E R A I D c o n n e c t o r s ( 4 0 - 1 p i n P R I _ R A I D 1 [ b l u e ] , I D E R A I D c o n n e c t o r s ( 4 0 - 1 p i n P R I _ R A I D 1 [ b l u e ] , I D E R A I D c o n n e c t o r s ( 4 0 - 1 p i n P R I _ R A I D 1 [ b l u e ] ,
S E C _ R A I D 1 [ b l a c k ] )
S E C _ R A I D 1 [ b l a c k ] ) S E C _ R A I D 1 [ b l a c k ] ) S E C _ R A I D 1 [ b l a c k ] ) S E C _ R A I D 1 [ b l a c k ] )
These connectors are for Ultra ATA 133/100/66 signal cables. These
connectors support up to four IDE hard disk drives that can be
configured as a disk array through the onboard IDE RAID controller.
Refer to Chapter 5 for details on how to set up RAID configurations.
P5GD2 PREMIUM
®
P5GD2 PREMIUM RAID connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_RAID1
PIN 1
SEC_RAID1
PIN 1
These connectors are set to IDE mode by default. In IDE mode, you can
connect IDE devices to these connectors such as boot/data hard disk
drives or optical drives. If you intend to create an IDE RAID set using
these connectors, set the I T E 8 2 1 2 F C o n t r o l l e r
I T E 8 2 1 2 F C o n t r o l l e r I T E 8 2 1 2 F C o n t r o l l e r I T E 8 2 1 2 F C o n t r o l l e r I T E 8 2 1 2 F C o n t r o l l e r item in the BIOS to
RAID Mode. See section “4.4.6 Onboard Devices Configuration” for
details.
• Before creating a RAID set using Ultra ATA hard disks, make
sure that you have connected the Ultra ATA signal cable and
installed Ultra ATA 133/100/66 hard disk drives.
• The system automatically assigns the boot sequence of ATAPI
devices connected to the IDE RAID connectors.
• The ITE ® 8212F controller supports a maximum of 2 Ultra ATA hard
disk drives.
• Set both drives either as Master or Slave before configuring a RAID 1
set.