Asus MAXIMUS VI GENE - Manual (Page 106)

3-20 Chapter 3: BIOS setup
Chapter 3
Tweakers’ Paradise
The subitems in this menu allow you to set the CPU ratio and features.
BCLK Tuning
VCCIN Shadow Voltage [Auto]
Pseudo Voltage for VCCIN. Configuration options: [Auto] [0.800] – [2.440V]
Termination Anti-Aliasing [Auto]
Termination Anti-Aliasing. Configuration options: [Auto] [Disabled] [Enabled]
Initial PLL Termination Voltage [Auto]
Initial Voltage at which CPU BCLKs are terminated. Maintaining a level close to CPU
Input Voltage will help BCLK Overclock.
Configuration options: [Auto] [0.0000] - [3.0000]
PLL Termination Reset Voltage [Auto]
PLL Termination Reset Voltage. Configuration options: [Auto] [0.0000] - [3.0000]
Eventual PLL Termination Voltage [Auto]
Eventual PLL Termination Voltage. Configuration options: [Auto] [0.0000] - [3.0000]
[Auto] [0.0000] - [3.0000]
PCH ICC Voltage [Auto]
Power Supply for the Integrated Clock Controller. Lower may be better. Configuration
options: [Auto] [0.6000] -[2.2000]
ICC Ringback Canceller [Auto]
Termination Anti-Aliasing. Configuration options: [Auto] [Disabled] [Enabled]
Clock Crossing VBoot [Auto]
The instantaneous voltage value when the rising edge of BCLK DN is equal to the
falling edge of the BCLK DP. Configuration options: [Auto] [0.1000] - [1.9000]
Clock Crossing Reset Voltage [Auto]
The instantaneous voltage value when the rising edge of BCLK DN is equal to the
falling edge of the BCLK DP. Configuration options: [Auto] [0.1000] - [1.9000]
Clock Crossing Voltage [Auto]
The instantaneous voltage value when the rising edge of BCLK DN is equal to the
falling edge of the BCLK DP. Configuration options: [Auto] [0.1000] - [1.9000]
BCLK Amplitude [Auto]
Allows you to adjust the magnitude of the BCLK.
Configuration options: [Auto] [��5] - [-5]
DMI Gen 2 [Auto]
Allows you to enable or disable DMI Gen 2. Auto means Enabled. Configuration
options: [Auto] [Enabled] [Disabled]
DMI De-emphasis Control [-6 dB]
Configure De-emphasis control on DMI. Configuration options: [-6 dB] [-3.5 db]
SATA Drive Strength [Auto]
SATA Drive Strength. Configuration options: [Auto] [��10] - [-10]