P7p55 lx ide connector, P7p55 lx internal audio connector – Asus P7P55 LX/JOOYON/SI User Manual

Page 37

Advertising
background image

ASUS P7P55 LX

1-25

2.

IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are

three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to configure your device.

Drive jumper setting

Mode of device(s)

Cable connector

Single device

Cable-Select or Master

-

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Black or gray

Slave

Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” ensure that all other device jumpers have the

same setting.

3.

Optical drive audio connector (4-pin CD)
These connectors allow you to receive stereo audio input from sound sources such as

a CD-ROM, TV tuner, or MPEG card.

P7P55 LX

P7P55 LX IDE connector

PRI_EIDE

NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.

PIN1

CD

Left

Audio Channel

GND

GND

Right

Audio Channel

P7P55 LX

P7P55 LX Internal audio connector

Advertising
This manual is related to the following products: