Extron Electronics IPCP 505 Setup Guide - Manual

1
IPCP 505 • Setup Guide
The Extron IPCP 505 IP Link ® Control Processor integrates Ethernet connection into AV systems to allow users to remotely
control, monitor, and troubleshoot AV equipment, including display devices and switchers. It includes an embedded web server,
multiple bidirectional serial ports, switched low voltage power output ports, relays, and configurable flex I/O ports for use in
applications that require control and monitoring of multiple devices within a large-scale AV system.
The IPCP 505 is configured using the free Extron Global Configurator (GC) software. The IPCP 505 integrates seamlessly with
Extron GlobalViewer
® Enterprise (GVE) software and the free GlobalViewer web-based AV resource management for remote
control applications. The IPCP 505 supports multiple TouchLink ® touchpanel interfaces over a standard Ethernet network. Global
Configurator and other useful software applications are available at www.extron.com .
Front Panel Features
IPCP 505
1 2 3 4 5 6 7 8
100
LINK
ACT
COM
IR/S
TX
RX
TX
RX
RTS
CTS
R
5
1
6
2
7
3
8
4
RELAY
FLEX
I/O
5
1
6
2
3
1
4
2
SWITCHED
12VDC
3
1
4 OVER
2 LIMIT
IR
7
3
8
4
Switched
12 VDC LEDs COM (Serial) LEDs IR/Serial LEDs
Relay LEDs
Flex I/O LEDs
IR Receiver Reset Button (recessed) Power LED
LAN/
Network
LEDs
Rear Panel Features
SWITCHED 12VDC
40W MAX TOTAL
LAN
IR/SERIAL RELAY
+ - + -
+ - + -
1 2
3 4 5
S G S G
6 7
S G S G
8
1
S G S G
2 3
S G S G
4
5 6 7 8
1 2 3 4
5A MAX
100-240V 50-60Hz
MAC:
00-05-A6-XX-XX-XX
S/N:
COM1
TX RX G G G
COM2
TX RX
TX RX G G TX RX
COM3
TX RX
G TX RX
COM4 COM5 COM6
G
COM7
CTS
COM8
TX RX RTS
G CTS TX RX RTS
FLEX I/O
1 2 3 4 G
Rear Panel
COM7, COM8
(RS-232, RS-422, RS-485)
COM1 - COM6
(RS-232)
Flex I/O
(digital
input/output,
analog input)
Power
Input
Switched 12 VDC
Power Output
MAC
Address
Ethernet
(LAN)
IR/Serial Relays
IPCP 505 • Setup Guide 1
Front Panel Features 1
Rear Panel Features 1
Cabling and Features 2
Power 2
Control — Serial (COM) 2
Control — IR/Serial 3
Control — Relay 3
Control — Flex I/O 3
Control — LAN (Ethernet) 4
About Global Configurator (GC) 4
What It Does 4
What To Set Up in GC 4
Configuration 4
Resources 5
Obtaining Control Drivers 5
Instructions, Information, and Assistance 5
Configuring for Network Communication 5
Network Configuration Options 5
Network Configuration Using ARP 5
Mounting 6
Setup Checklist: How to Proceed With Installation 6
Contact information 6