Extron Electronics MTP DA8 Setup Guide - Manual

IMPO
RTAN
T:
Go to www
.extron.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
MTP DA4 and DA8 • Setup Guide
This guide provides basic instructions for an experienced installer to set up and
J9
Disable
Mute
(Default)
or Enable
Mute
J3
Serial or Audio
(Default)
operate an Extron MTP DA4 or DA8 distribution amplifier.
Pre-installation — Jumpers
See the figure at the right or see “Termination and Mute Jumpering” in the
MTP DA4 and MTP DA8 User Guide for more information.
NOTE: The jumpers have no effect when the DA is part of an MTP CV/SV
series, or VTT001/VTR001 system.
Jumper J3
This sets the DA to properly terminate RGB video as well as the audio (default) or serial portion of the input signal.
Jumper J9
This sets the DA to always pass the audio or serial link regardless of the contact closure mute status (default). It can also be set
to mute the audio or serial link when its video mute function is activated.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP DA as required. A mounting example is shown below).
See “Mounting” in the user guide for more mounting options.
Use 2 mounting holes on
opposite corners.
1/2 Rack Width False Front
Face Plate
(2) 4-40 x 3/16" screws
6" Deep Rack Shelf
MTP DA SERIE
S
Figure 1. Mounting the MTP DA
Step 2 — Input from the Transmitter
Terminate a TP cable as shown in figure 3 . Connect the cable into a MTP transmitter
1 2 3 4 A/V INPUT A/V OUTPUTS
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Blue Blue
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins: and into the AV input connector.
Step 3 — Outputs to the Receivers
Terminate up to four or eight (depending on model) TP cables as shown in the figure to the
right. Connect the cables into the DA AV output ports and into receivers that are
compatible
with the transmitter.
NOTES:
• The inputs and outputs should be terminated using the same standard on both
ends of the cable.
• Only use the TIA/EIA T568A standard when using Enhanced Skew-Free™ AV
cable.