Neff D4654X0 - Manual (Page 28)

28
Installation inside the wall cupboard
2. Align the handle and screw onto the
appliance with the two enclosed
screws.
7. Feed the mains connection cable
through the aperture into the upper
cupboard and connect the pipe.
8. Connect to the power supply.
9. If required, shorten the wall cover to the
required size (e.g. saw off) and screw to
the upper cupboard.
Attaching a handle:
❑ A handle must be attached to the
filter drawer.
❑ This handle can either be a wooden strip
that matches the kitchen
cupboards or a the handle that is
available as an optional accessory (see
section on optional accessories in the
user instructions).
1. Mark two points on the handle with the
enclosed template O
III and make holes
with a bradawl.
If the holes are drilled:
l
2 mm – max. 10 mm deep.
14,5
598
350
3. Insert the filter frames (see Operating
Manual).
Note: The extractor hood housing inside
the wall cupboard can be boarded up (e.g.
with chipboard).
Please observe the following:
– The shelf must not be rest upon the
extractor hood housing.
– The board at the front should not be
attached to the housing.
– Provide access for customer service.
Removal:
The extractor hood is removed in reverse
sequence.
Note: In circulating-air mode the activated
carbon filter and plastic holder must be
removed in order to gain access to the
mounting screws and installation aids.
Weight in kg:
The manufacturer reserves the right to make design
alterations in the interests of technical development.
Exhaust air Re-circulating air
9,5 10,5