MoTeC Snowmobile Plug-In ECU - Manual (Page 16)

8 Ski-Doo 2009-Current Installation MoTeC
Installation
Note – the Ski-Doo connectors are labelled A and B and are keyed so
that only the correct plug can be inserted. If the slide-lock on the plug
will not slide shut, then the plug is fitted into the wrong connector.
For the ECU to function normally all supplied devices must be connected:
• STC-K device plugged into 6 pin socket labelled ‘STC’
• IGN4 device plugged into 6 pin socket labelled ‘COIL’ and 4 pin
socket labelled ‘IGN’.
These devices can all be secured by zip-ties.
Configuration File
The Ski-Doo Snowmobile Plug-in ECU is compatible with 1200 4-Tec
models from 2009 to 2012.
All year models of the Ski-Doo Snowmobile Plug-in ECU use the same
configuration file.
To mimic all original Ski-Doo functions including dashboard alerts, the Ski-
Doo Snowmobile Plug-In ECU requires M400 firmware version 3.53C or
higher.
Output Test Function
To test if all outputs are correctly wired to the relevant injectors and coils,
the ECU Manager software has an output test function available. If you
would like to use this function in a Ski-Doo installation refer to the notes in
the Appendices (
Output Test Function).