PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 16)

ULTRA EDGE SEQUENTIAL 6 /05/2002
16
Position cursor next to desired parameter, enter appropriate value, and press the “ENTER” key. Press “TOOLS” key
to open next screen.
T # 1 S # 1 / 1
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
To save a newly created tool, position the cursor next to Exit editing command and press the “ENTER” key.
T # 1 S # 1 / 1
R e p e a t 2
E x i t e d i t i n g <
T O O L S - n e x t B K S P - P r e v
Position the cursor next to Save command and press the “ENTER” key
T # 1
S a v e <
S a v e a s
T O O L S - n e x t B K S P - P r e V
T o o l # 1 S a v e d
4.2 HOW TO EDIT AN EXISTING TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and FEED STATUS screen is displayed. If the current screen is not FEED STATUS one then press
the “OPER” key to bring it up.
Press “TOOLS” key, position the pointer next to EDIT TOOL command and press the “ENTER” key.
E d i t T o o l <
A c t i v a t e T o o l
C r e a t e N e w
P r e s s T O O L S t o E x i t
Enter the desired tool number or select it from the tool list using “ ↑” and “↓” keys and press the “ENTER” key again.
E d i t T o o l #
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
E d i t T o o l # 1
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t