CEMB USA C71_2 SE evo (B) - Manual (Page 21)

21
Use and maintenance manual Rev. 10-2012
ENGLISH
Distance between the spokes less
than 18 degrees.
1. The minimum distance between the spokes where the
unbalance is to be split must be greater than 18 degrees.
2. Repeat the SPLIT function increasing the distance between
the spokes.
Distance between the spokes
greater than 120 degrees.
1. The maximum distance between the spokes where the
unbalance is to be split must be less than 120 degrees.
2. Repeat the split function increasing the distance between the
spokes.
First spoke too far from the unbal-
ance
1. The maximum distance between the unbalance position and
the spoke must be less than 120 degrees.
2. Repeat the split function increasing the distance between the
spokes and the unbalance.
Unbalance
incorrect
with back
centring
cones
Wheel slipping on the adapter because
the BP system is at the end of travel or
because of incorrect fitting of the tyre
tie-rod
Mount the wheel in vertical position and push the sleeve up against the
wheel. If necessary, repeat locking/unlocking/locking and perform the
procedure again.
Diagnostics