Datamax-O'Neil LP3 Hand Strap Clip Replacement Kit - Manual

LP3 Hand Strap Clip Replacement
Kit
(220260-000)
Use the LP3 Hand Strap Clip Replacement Kit for
replacing the male snaps and the split rings on LP3
printers.
The LP3 Hand Strap Clip Replacement Kit comes with
the following parts:
• Male Snaps (2) (part # 280294-000)
• Split Rings (2) (part # 370213-000)
Replacing the Male Snaps / Split
Rings
It is suggested that the hand strap be removed before
replacing the male snaps or the split rings.
Removing the Hand Strap
1. Remove the hand strap from the LP3 printer by
pressing both of its tabs at the same time, and then
gently pulling the hand strap away from the male
snap.
2. You can now choose to remove either the male
snap, the split ring, or both.
Replacing a Male Snap
1. Make sure the hand strap is removed.
2. Remove the male snap from the split ring by
inserting an item, such as a flathead screwdriver or
a coin, into the split ring.
3. Slide the male snap along the split ring and
continue until the male snap is removed.
4. Slide the new male snap on until it is secure.
5. Reattach the hand strap.
Male Snaps (2) Split Rings (2)
Male Snap Tabs