Datamax-O'Neil PrintPAD Dolphin 99EX User Guide - Manual (Page 5)

PrintPAD Dolphin 99EX USER GUIDE
3
LEDs, see PrintPAD Dolphin 99EX LEDs and Indicators on page 7 .
Determining Battery Condition
You can determine the relative battery condition by printing a self-test. For more information, see Printing a Self-Test
on page 6 . On the printout, “Battery Volt” varies between 6.8 and 8.4 volts.
Using a Handheld Computer (HHC)
1. Insert the handheld into the cavity by sliding it in from the top.
2. Press down until the handheld is fully latched and seated (Figure 5).
Compatible Handheld Computers
Installing the Battery Spacers
1. Verify the battery type being used in the Dolphin 99EX Handheld unit.

Standard Battery (99EX-BTSC-1 Dolphin 99EX Standard Battery Pack (Li-Ion, 3.7V, 11.3 Watt Hour)

Extended Battery (99EX-BTEC-1 Dolphin 99EX Extended Battery Pack (Li-Ion, 3.7V, 18.5 Watt Hour)
Note: To obtain full battery capacity, a new battery must cycle through two to three charges. To restart a charge,
unplug the power cord. Wait 30 seconds, then replug the power cord.
The Dolphin 99EX Handheld Computer will charge while power is plugged into the DC power port.
Caution: Do not plug DC power into the internal and external power ports at the same time.
Do not plug the DC power supply into the printer if the printer is being charged by means of external charge
contacts.
Caution: There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
The operating temperature of this portable printer is 50° C. However, the operating temperature when used with
Datamax-O’Neil power supply for charging the portable printer is limited to 40° C. Charge the printer in a suitable
location that meets this temperature requirement.
(For US/Canada) Use only the Datamax-O’Neil part number 220240-100 power supply with this product.
Note: The PrintPAD 99EX series is intended for use with the UL Listed Handheld computer Honeywell, Model
Dolphin 99EX.
Note: If the extended battery is not being used, the battery spacers must be installed. The battery spacers do not
come installed.
Figure 5